|July 1, 2013, 06:04||
Save Message Log automatic with Replay Script
maybe you know the answer to this simple question. For my optimization loop I am using a 3D hexa mesh.Lets say for a duct. I want ICEM to write out the curve length so I can guarantee that the number of cells along the duct is always equal. The info for the curve length is easy to generate manually with "Info->Curve length" and then the message log file can be saved.
I f i am writing a replay script nothing happens while clicking "Info->Curve length" in the replay control monitor. Also the command button "save below the message log window does not generate any output in the replay script (see attached figure).
Programmer's guide was not helpful so far.
Saving the complete hexa project leads to no helpful log file.
Do you have any idea how to tell ICEM to give me the information of the curve length in an automatic approach??
|message log, replay script|
|Thread||Thread Starter||Forum||Replies||Last Post|
|[DesignModeler] Macro / Script for automatic geometry import||wasabi||ANSYS Meshing & Geometry||13||November 24, 2014 01:07|
|[ICEM] Replay control - save picture||zboud||ANSYS Meshing & Geometry||12||November 16, 2014 17:29|
|automatic save and exit in GUI||cinwendy||FLUENT||3||March 15, 2013 12:57|
|[ICEM] Automatic mesh generation script surface intersection problem||stuart23||ANSYS Meshing & Geometry||0||May 13, 2011 01:10|
|Error message in CFX-10||CFDworker||CFX||2||October 12, 2007 07:23|