|
[Sponsors] |
July 3, 2013, 05:46 |
First layer height decrease
|
#1 |
New Member
Join Date: May 2013
Posts: 1
Rep Power: 0 |
Hello,
I am running a Fluent simulation of a 2D model of a car in a wind tunnel, using k-epsilon method. I'd like to have all my y+ along the top side of the car the nearest to 30 to have the better precision. The "problem" is that the velocity is increasing along the windshield (flow section decreasing), the same for the y+ values. My question is : is there a way to decrease the size/height of the boundary cells elements from the bottom to the top of the windshield ? (to remain the y+ at value) Thank's in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] First layer height - units | saisanthoshm88 | ANSYS Meshing & Geometry | 1 | May 16, 2012 14:16 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
Height of boundary layer | DAK565656 | CFX | 2 | April 19, 2007 11:30 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |