CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Shadow region not created (http://www.cfd-online.com/Forums/ansys-meshing/120465-shadow-region-not-created.html)

kartrmswy July 8, 2013 02:28

Shadow region not created
 
Hello! :)

I need to analyse a 2D (axial) cross section of a dual pipe heat exchanger for a multiphase heat transfer problem.

I created the geometry on DM using sketches and surfaces - but I'm facing an issue with the walls: I need shadow regions created so that I can enable coupled heat transfer between the walls. I have explicitly specified multiple (fluid, solid, fluid) for the inner pipe region, pipe wall and the annulus.

Any way I can manually add a shadow region or get FLUENT to recognize that this wall is an interface between a solid and fluid?

Thanks!

vasava July 25, 2013 05:07

Did you find a solution?


All times are GMT -4. The time now is 05:24.