CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] Two edges instead of one (https://www.cfd-online.com/Forums/ansys-meshing/120944-two-edges-instead-one.html)

abc197 July 17, 2013 14:40
Two edges instead of one
 
This may be one of the simplest of gambit, but I am stuck. While subtracting smaller face from bigger one(retaining smaller one), at the interface of both, I am getting two edges generated for the same interface edge. Same is happening in case of volumes(two faces are generated). Can anybody explain this? Problem is, which one am I supposed to select while assigning boundary conditions or zones.

reza_farzin July 18, 2013 13:34
Quote:
Originally Posted by abc197 (Post 440384)
This may be one of the simplest of gambit, but I am stuck. While subtracting smaller face from bigger one(retaining smaller one), at the interface of both, I am getting two edges generated for the same interface edge. Same is happening in case of volumes(two faces are generated). Can anybody explain this? Problem is, which one am I supposed to select while assigning boundary conditions or zones.
after subtract, you can connet two edges(interface) by edge/connect

-mAx- July 23, 2013 00:57
pictures always help

abc197 July 23, 2013 06:58
Thanks for your replies, I have managed to disconnect the edges.


All times are GMT -4. The time now is 08:45.