CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > ANSYS Meshing & Geometry

[ICEM] 2D to 3D meshing

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   July 22, 2013, 11:10
Default 2D to 3D meshing
  #1
New Member
 
Piyush
Join Date: Jul 2013
Location: Chennai
Posts: 4
Rep Power: 3
Piyush Jadhav is on a distinguished road
hello all,
I am trying to make a 3D VAWT(vertical axis wind turbine) model in ICEM. we had done 2D meshing successfully, we got results which are good enough to proceed ahead. Now converting that 2D mesh to 3D we are facing couple of problems. One is that mesh cell height is uniform through out the length of the extrusion direction which has to be fine at the edges and corners. The other problem is that the domain height and the rotor height are same where we want the rotor height less than domain height atleast in 5 times ratio.

Thanks in advance
Piyush Jadhav is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[ANSYS Meshing] Can I use ANSYS Meshing for manual meshing? Kirjain ANSYS Meshing & Geometry 3 June 12, 2012 08:35
Best Meshing scheme for Cylinder Nutrex Main CFD Forum 4 July 29, 2008 11:03
Meshing locks workbench window. andy2o CFX 0 February 1, 2008 05:01
Singularity of grid?Volume meshing vs face meshing Ken Main CFD Forum 0 September 4, 2003 11:09
Volume Meshing & Face Meshing? singularity of grid ken FLUENT 0 September 4, 2003 11:08


All times are GMT -4. The time now is 18:00.