|
[Sponsors] |
July 30, 2013, 12:58 |
pipe
|
#1 |
New Member
Pawel
Join Date: May 2013
Posts: 11
Rep Power: 12 |
hello,
i am new to cfd. can someone help me? is this proper mesh? or should i change something? thx a lot for help. |
|
August 6, 2013, 08:18 |
|
#2 |
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 22 |
Although it looks good, it depends on what you want to simulate.
|
|
August 6, 2013, 11:15 |
|
#3 |
New Member
Pawel
Join Date: May 2013
Posts: 11
Rep Power: 12 |
hello, i try to simulate swirl velocity. I made measurements on real models. now i am trying to simulate this.
|
|
August 7, 2013, 03:00 |
|
#4 |
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 22 |
Most of your wedge elements (the ones in the boundary layer) seem to be of low quality. You can try to improve by playing with mesh size.
Also you can run a test example with your mesh. If the 'viscosity limited' error persists then you may have to further refine your mesh. Remember the 'viscosity limited' error is ok/tolerable in the beginning of the simulation (say first few time steps or iterations) but not later than that. |
|
August 18, 2013, 11:51 |
|
#5 |
New Member
Pawel
Join Date: May 2013
Posts: 11
Rep Power: 12 |
i still get problems with this profile. i try different kind of mesh, but always simulation results are incorrect.
can you look on my profile i give me some advice? http://www.speedyshare.com/hbxTP/Geomnorm.agdb thx a lot for help |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] DesignModeler Pipe within pipe | shields | ANSYS Meshing & Geometry | 13 | November 25, 2018 22:14 |
Double Walled Pipe Boundary | dahvqaz | FLUENT | 2 | December 5, 2012 10:14 |
pipe in pipe heat exchanger | JohannV | FLUENT | 3 | December 3, 2009 02:53 |
My Revised "Time Vs Energy" Article For Review | Abhi | Main CFD Forum | 2 | July 9, 2002 09:08 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |