yes i have just figured it out after i posted it.I'm gonna try to mesh with filled holes now.Thanks Ali.
|
Maybe this can help you. This is Diamondx approach. I just try to repeat it. Here the result.
Multiple Pipe In Cylinder Blocking Here files: https://www.dropbox.com/s/0blxqh8z2p...20Cylinder.rar |
@javi,
Good video, thanks for sharing this ! |
Quote:
in your uploaded picture, you did not block the nozzle of exchanger. for blocking you should be split nozzle block http://8pic.ir/images/95435552099944766571.jpg so, after this step you can split block for the tubes. for delete block go.... blocking menu\delete block |
Hey guys,
I have been trying to mesh this geometry with nozzle nowadays.I know it should not be that hard yet it is hard to figure it out what is going on as a begineer tbh.So i have done this blocking (below) many times and i only got one successful mesh at all.So here question is,is there any further ways to improve this mesh better,(i alrdy tried smooth mesh)?All suggestions would be appericiated. http://imagizer.imageshack.us/v2/800...0/600/m7jd.jpg |
All times are GMT -4. The time now is 18:27. |