[GAMBIT] Meshing 2D Fins Object - Page 2 -- CFD Online Discussion Forums

September 16, 2013, 04:09

#21

spartacurse

New Member

Ikhsan

Join Date: Sep 2013

Posts: 15

Rep Power: 12

Quote:

Originally Posted by -mAx-

Clearly a connectivity problem
try to connect edges (/All)
If it is not successfull , then you will need to split the "long" edge from bottom domain with each "small" edge from channels (one by on), and after again a connect /all

yeah it was a connectivity problem. I managed to solve it using the latter solution. thanks again.

Page 2 of 2

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
engineFoam with layers - pressure problems when adding layers	mturcios777	OpenFOAM Running, Solving & CFD	23	January 4, 2023 21:56
[foam-extend.org] Error compiling OpenFOAM-1.6-ext	Canesin	OpenFOAM Installation	137	January 20, 2016 14:56
[GAMBIT] meshing of wavy fins	dldl	ANSYS Meshing & Geometry	8	February 18, 2015 13:10
Compilation error OF1.5-dev on Suse10.3	darenyang	OpenFOAM Installation	0	April 29, 2009 04:55
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 07:36

All times are GMT -4. The time now is 08:51.