|
[Sponsors] |
August 26, 2013, 18:19 |
Icem mesh error
|
#1 |
Member
Amir
Join Date: Sep 2012
Posts: 47
Rep Power: 13 |
Hi guys,
I have created my mesh in ICEM and also I have checked the quality and did the smoothing in ICEM. While checking the mesh it asked me tons of errors reagding unattached edges and etc. I had three options, ignore, create subset or fix it. (The last one only for some of the errors) I tried either of them, after exporting the mesh in FLUENT, I faced with the following terms: 1. 38 cells have only faces... 2. Check mesh failed 3. check verbosity Could you please help me... Thanks in advance |
|
August 28, 2013, 13:39 |
|
#2 |
New Member
|
Can you attach a photo or the geometry file if this ok with you.
|
|
August 28, 2013, 15:22 |
|
#3 |
Member
Amir
Join Date: Sep 2012
Posts: 47
Rep Power: 13 |
Sure.
I have attached some helpful pictures. Thanks in advance, Amir |
|
August 29, 2013, 13:58 |
|
#4 |
New Member
|
The pictures can show how the errors look but sure geometry will be needed to check it ,if you are fine with that?
Sorry for the basic question but have you choose the material points for your model or not? and how did you generate the mesh ? The errors occured in surface or volume mesh check? regards |
|
September 3, 2013, 01:16 |
|
#5 | |
Member
Amir
Join Date: Sep 2012
Posts: 47
Rep Power: 13 |
Quote:
Hi Hazem, Thanks for your reply. the errors occured in volume mesh check. I used Robust, then Quick and then create the prisms Best, Amir |
||
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] an error in Calculator's equation | immortality | ParaView | 12 | June 29, 2021 00:10 |
Compiling dynamicTopoFvMesh for OpenFOAM 2.1.x | Saxwax | OpenFOAM Installation | 25 | November 29, 2013 05:34 |
Errors in UDF | shashank312 | Fluent UDF and Scheme Programming | 6 | May 30, 2013 20:30 |
[swak4Foam] installing funkySetFields | igo | OpenFOAM Community Contributions | 1 | November 20, 2012 20:16 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |