|September 3, 2013, 06:48||
Join Date: Jun 2011
Posts: 51Rep Power: 4
I'm simulating a fully developed turbulent flow in a pipe of a non-Newtonian fluid. The turbulence model is the LS model, low Reynolds turbulence model. My doubt is related with the mesh, the geometry considered is a 2D geometry axisymmetric. I didn't perform the mesh with a boundary layer, but I'm testing a non-uniform mesh with y+ (first node) = 1. Do I need include a boundary layer?
Sorry for this question, but I'm really confuse....
|Thread||Thread Starter||Forum||Replies||Last Post|
|Prism Layer (Boundary Layer) Thickness||Peter-27||STAR-CCM+||3||June 18, 2013 06:54|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||2||November 25, 2012 08:54|
|Grid Independence of Boundary layer||Luigi_||Main CFD Forum||0||December 14, 2011 13:42|
|Boundary Layer Question||scottneh||STAR-CCM+||3||September 30, 2010 14:21|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|