 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Generating a 3D body from a series of surfaces |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 20, 2013, 14:30
|
Generating a 3D body from a series of surfaces
|
#1 |
|
New Member
Evan
Join Date: Jul 2013
Posts: 2
Rep Power: 0  |
All,
I have been looking into modeling a flapping wing from data which gives the deformation of the wing over time (through DIC). It allows me to look at one given time and find the ordered pair (x,y,z) for different points in the wing. I am then looking to generate a 3D model with these points. So far I have been able to get the points into Fluent DM and have been able to generate the necessary surfaces between them. Example picture a, Example picture b. However, I can not figure out how to turn the series of faces into a 3D body. Any help would be appreciated. Evan |
|
|
|
|
|
September 13, 2013, 04:32
|
|
#2 |
|
Senior Member
Josef Runsten
Join Date: Jul 2010
Location: Gothenburg, Sweden
Posts: 188
Rep Power: 23  |
in DM: Create > Body Operation > Sew?
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [DesignModeler] Generating solid body between two bodies. | yshi095 | ANSYS Meshing & Geometry | 8 | October 1, 2013 06:07 |
| Doxygen documentation | Tanay | OpenFOAM Installation | 9 | September 23, 2011 11:40 |
| ParaView and Qt 4.3.5 on Mac OS X 10.6 | Adrian | OpenFOAM | 3 | August 8, 2010 03:16 |
| heat generating body inside fluid volume | NITUL KALITA | FLUENT | 0 | December 14, 2008 13:48 |
| Thin surfaces within a body using DesignModeler? | Forrest | CFX | 7 | April 5, 2005 08:21 |
Linear Mode
