 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] How to have ORFN pat before generating multi zone meshing |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 9, 2013, 03:09
|
How to have ORFN pat before generating multi zone meshing
|
#1 |
|
Senior Member
Astio Lamar
Join Date: May 2012
Location: Pipe
Posts: 186
Rep Power: 13  |
Hello!
I want to generate a multi-zone mesh for a geometry. there are several volume inside the domain that should be meshed and some others not. So As a routine I select both "Mesh internal domains" and "Flood fill after completion". But I have to add the zones which should not be meshed in ORFN part. But this part will appear after the mesh is generated. So is there any possibilities to have this part before generating a mesh? Thanks. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GAMBIT] Multi Element Airfoil Meshing | wanfuhh | ANSYS Meshing & Geometry | 1 | May 6, 2013 02:45 |
| T junction - meshing wall zone in Gambit | John | FLUENT | 3 | August 29, 2005 10:09 |
| how to pass bc from one zone to second zone | Maria | FLUENT | 2 | March 15, 2004 23:12 |
| Sliding mesh error | Karl Kevala | FLUENT | 4 | February 21, 2001 15:52 |
| Fluent incident radiation problem | Michael Schwarz | Main CFD Forum | 0 | October 21, 1999 05:56 |
Linear Mode
