CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Converting or projecting Edge (of blocking) to generate curve (http://www.cfd-online.com/Forums/ansys-meshing/124640-converting-projecting-edge-blocking-generate-curve.html)

AshwaniAssam October 9, 2013 23:55

Converting or projecting Edge (of blocking) to generate curve
 
Hi,

My problem is that our solver reads CGNS file. Now, I have a mesh with multiple blocks. A face is shared by 3blocks. But the face is one surface and named like inlet. Now, I want this face should be divided in 3 surfaces to match the respective blocks.

(This will help our solver to recognize each sub-face as part of respective blocks, which are understood to be zones under CGNS nomenclature. )

The mesh file is of NACA 0015.


All times are GMT -4. The time now is 06:29.