[ICEM] Converting or projecting Edge (of blocking) to generate curve -- CFD Online Discussion Forums

October 9, 2013, 23:55	Converting or projecting Edge (of blocking) to generate curve	#1
AshwaniAssam Senior Member Ashwani Join Date: Sep 2013 Location: Hyderabad Posts: 154 Rep Power: 12	Hi, My problem is that our solver reads CGNS file. Now, I have a mesh with multiple blocks. A face is shared by 3blocks. But the face is one surface and named like inlet. Now, I want this face should be divided in 3 surfaces to match the respective blocks. (This will help our solver to recognize each sub-face as part of respective blocks, which are understood to be zones under CGNS nomenclature. ) The mesh file is of NACA 0015.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[ANSYS Meshing] blocking 2D planar, problem associate edge to curve	hadrien51	ANSYS Meshing & Geometry	10	February 21, 2012 12:37
Actuator disk model	audrich	FLUENT	0	September 21, 2009 07:06
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

All times are GMT -4. The time now is 20:31.