|October 14, 2013, 12:46||
Multizone will not form 3D elements
Join Date: Oct 2013
Posts: 2Rep Power: 0
I have been trying to use the multizone method to get a hex mesh with an inflation layer for an external flow problem.
I am just trying to simulate flow around a horizontal and vertical pipe and their boundary interaction. I want to have an inflation layer around each pipe to better resolve the boundary layer.
When I try and use the multizone method, errors come up stating either:
- multizone mesh failed during meshing of blocks
- the 3D fill could not generate any volume elements
I have tried cutcell as well but the inflation layers do not generate.
Any advice on how to handle this issue would be greatly appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Hybrid mesh for 2D boundary layer||Bigio||ANSYS Meshing & Geometry||32||January 9, 2014 11:26|
|Question about FDM and supersonic flows||Guillaume_Fournier||Main CFD Forum||2||January 20, 2013 23:41|
|MultiZone Mesh||sepidecent||CFX||0||June 19, 2012 20:13|
|[ICEM] Negative Volumes & 7 node HEXA elements||mr_stoked||ANSYS Meshing & Geometry||1||September 21, 2010 12:45|
|Penetrating elements in extruded mesh||Michael P||CFX||2||May 20, 2005 08:06|