 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] volume mesh instead of surface mesh Octree method |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 28, 2013, 22:09
|
volume mesh instead of surface mesh Octree method
|
#1 |
|
New Member
Join Date: Oct 2013
Posts: 9
Rep Power: 12  |
I imported geometry from ANSYS design modular. I have performed 3D boolen operation on the geometry as well in Design Modular but when I mesh in ICEM using OCTREE method all I get is surface mesh. How can i get a volume mesh?
|
|
|
|
|
|
October 28, 2013, 22:10
|
|
#2 |
|
New Member
Join Date: Oct 2013
Posts: 9
Rep Power: 12 |
PS: I am following steps as instructed in Tetra/Prism Mesh Generation for a Helicopter. I tried to manage using cut plane where i can only see meshes around surface
|
|
|
|
|
|
|
| Tags |
| surface mesh, volume mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
| [blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
| On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
Linear Mode
