 |
 |
 |
|
|
|
[Sponsors] | ||||
November 10, 2013, 13:47
|
Blocking an Intake
|
#1 |
|
New Member
Yu Omori
Join Date: Jul 2013
Posts: 13
Rep Power: 12  |
Hi,
I'm trying to figure out how to effectively block an intake system. The image attached is the model. It is half of the intake as it is symmetrical. I am not that experienced with blocking and I was wondering how some of the more seasoned members here would approach the problem. Below is my attempted blocking of the problem region. I have not included the o-grid for the valve yet. This results in some weirdness with the premesh, on the face of the block and on the side of the intake port near the valve. Any help is greatly appreciated! Yu |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Problem to load the blocking | biasilveira | ANSYS Meshing & Geometry | 2 | February 24, 2013 22:04 |
| [ICEM] Blocking and Symmetry | BrolY | ANSYS Meshing & Geometry | 32 | August 24, 2012 03:13 |
| [ICEM] Using Blocking with ICEM (infinite blocking lines appeared) | Touré | ANSYS Meshing & Geometry | 2 | August 5, 2012 17:27 |
| [ANSYS Meshing] Air flow through intake manifold | zscheck | ANSYS Meshing & Geometry | 5 | March 15, 2012 21:41 |
| designing an air intake under gambit | joseph guaragna | FLUENT | 0 | November 20, 2001 06:21 |
Linear Mode
