CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [BladeModeler] Bladegen data import wizard (http://www.cfd-online.com/Forums/ansys-meshing/126009-bladegen-data-import-wizard.html)

ArslanOZCAN November 6, 2013 02:58

Bladegen data import wizard
 
Hi everyone;

I draw a 3D hydraulic turbine blade in Solidworks and import it into Ansys Bladegen in Igs format using Data import wizard. I submitted whole step but at the last step it asks for Leading Edge and Trailing Edge eliptic ratio. There are red squares, at both LE and TE and asks to confirm these points. How should i replace and submit them? What are these squares defining?

When i pass this step and open the final geometry in TurboGrid or Design modeler trailing edge is generated as cutted randomly which is wrong. What can be the problem ?

Best Regards.


All times are GMT -4. The time now is 07:31.