Mesh error
1 Attachment(s)
Hey,
I'm trying to generate the mesh for a NACA4412 Airfoil... Therefore I use this tutorial https://confluence.cornell.edu/displ...Airfoil+-+Mesh The only difference is that I use a NACA4412 geometry instead of NACA0012. If I generate the mesh I get strange results in the upper right corner (see attached file). I tried it several times from the beginning but the result is always the same:confused: Anybody an idea? Thanks for any advice! :) |
I am not an ansys meshing, but I can swear this have been discussed ealier in the forum , just use the search tool or google search using the appropriate keywords. This was discussed more than one time. all the people who followed that cornell tutorial ends up with a mesh like yours. I don't know if the tutorial is faulty... Good luck
|
Is this domain decomposed into individual bodies?
You may have split edges in that block. Check to see that they are all continuous. Also, the Multizone mesher will do a better job here. |
try with edge sizing hard on the upper right ok
|
1 Attachment(s)
Thanks for your responses:)
I've used Edge sizing hard. I've changed some things, too. Now I'm using 2 Mapped Face Meshing (1. both quarters on the left and the quarter bottom right, 2. upper right one) and now the Mesh looks better, but still not perfect... |
All times are GMT -4. The time now is 00:56. |