 |
 |
 |
|
|
|
[Sponsors] | ||||
November 10, 2013, 06:06
|
Primitive 2D region in CFX
|
#1 |
|
Senior Member
Henry Arrigo
Join Date: Jun 2010
Location: Italy
Posts: 100
Rep Power: 15  |
Hello all;
I generated a structured mesh over a swept wing in ICEM and then converted to .cfx5 and opened in ANSYS CFX. After importing the mesh I detected a primitive 2D region that can be seen in the attached photos. I don t know wh is the problem. Although I assigned the surrounding surfaces next to wing to wing part, there seems to be some non-assigned elements which forms the primitive 2D region. Does anybody have any idea what s the problem and how can I fix it? Thank you |
|
|
|
|
|
November 10, 2013, 08:32
|
|
#3 |
|
Senior Member
Henry Arrigo
Join Date: Jun 2010
Location: Italy
Posts: 100
Rep Power: 15 |
I haven t gone through solving yet because I thought it would result in convergence problem. The point is when I use Ansys meshing the whole wing forms a single part in CFX without any non-assigned elements.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFX Treatment of Laminar and Turbulent Flows | Jade M | CFX | 18 | September 15, 2022 07:08 |
| How to ignore some 2D primitive region in CFX-Pre | KK | CFX | 4 | April 15, 2014 11:05 |
| Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 13:12 |
| Heattransfer between two fluids with chtMultiRegionFoam | Black-Pearl | OpenFOAM Running, Solving & CFD | 1 | September 7, 2013 08:03 |
| ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
Linear Mode
