|
[Sponsors] |
[ICEM] Calling for Help in icem Edge Parameters |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 10, 2013, 14:03 |
Calling for Help in icem Edge Parameters
|
#1 |
New Member
Louis
Join Date: Aug 2013
Posts: 1
Rep Power: 0 |
Hello, Everyone,
i am writing my thesis in the field of 3-Blades VAWT. I have finished the whole topology. I tried to split all three blade edges into 240 nodes so that the length(spacing) of one element could be around 0.001m. I tried several times. But blade1 seems to be always twice dense as much as blade2 and blade3. That means when i set nodes number 240 for both blade 2 and blade 3, nodes number for blade 1 will automatically changed to 490, and the spacing will be changed to 0.0005m, which i donot want. If i change nodes number for blade1 to 240, nodes number fo blade2 and blade3 will automatically be changed to 117 and 118, and the corresponding spacing is 0.002m, which i donot want nor. Do i make a mistake in the mesh law? if not, what is then up? thanks guys. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Shifted Periodic topology | venkat_aero2007 | ANSYS Meshing & Geometry | 17 | August 27, 2013 01:41 |
HELP Beginner ICEM initialize PRE-MESH parameters | guest7777 | CFX | 2 | October 18, 2007 06:18 |
number of nodes on an edge in ICEM CFD | strider | Main CFD Forum | 2 | July 24, 2006 15:31 |
ICEM - irregular mesh at edge ? | ingear | CFX | 3 | October 18, 2005 14:31 |
Who know how to use the split edge in icem cfd? | carnivore | Main CFD Forum | 2 | December 16, 2004 23:32 |