|November 11, 2013, 09:33||
Problem continuing 2D boundary layer to adjacent surface
Join Date: Jul 2011
Posts: 1Rep Power: 0
I'm having problems creating a satisfactory 2D boundary layer. Specifically, the b-layer at the wall is not continued properly to the lines without boundary layer (i.e. inlet and outlet), see attached picture. The max. prism angle is set to 180°.
It's noteworthy that the problem does not exist for my 3D meshes.
Any help is much appreciated!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Catalyst Modelling Boundary Problem (Surface reaction)||Fritz||STAR-CCM+||0||August 6, 2013 09:10|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||2||November 25, 2012 09:54|
|Boundary layer meshing problem in Gambit||Crystal||FLUENT||0||June 12, 2009 20:58|
|Boundary layer meshing problem in Gambit||Crystal||Main CFD Forum||0||June 12, 2009 14:32|
|errors||Fahad||Main CFD Forum||0||March 23, 2004 14:20|