|
[Sponsors] |
November 15, 2013, 11:53 |
Inflation problems
|
#1 |
Member
Nikola
Join Date: Sep 2013
Location: Madrid, Spain
Posts: 60
Rep Power: 12 |
Hi everyone!
I am using this tutorial (https://confluence.cornell.edu/displ...oil+-+Geometry) to simulate the 2D flow over an airfoil. I've done everything as it's shown in the tutorial but I have to include the inflation boundary layer too. When I open mesh control > inflation if I select the 4 faces (as shown in the picture below) i get: Active: No, invalid method. What should I do? |
|
November 15, 2013, 11:54 |
|
#2 |
Member
Nikola
Join Date: Sep 2013
Location: Madrid, Spain
Posts: 60
Rep Power: 12 |
This is how it looks like after I've selected the 4 faces.
|
|
November 17, 2013, 03:32 |
|
#3 |
Senior Member
Stuart
Join Date: Jul 2009
Location: Portsmouth, England
Posts: 733
Rep Power: 25 |
If you are following that tutorial you will see the Inflation is not used. Instead edge sizings are used with biased node distributions.
|
|
November 17, 2013, 12:02 |
|
#4 |
Member
Błażej Popławski
Join Date: Jul 2013
Posts: 34
Rep Power: 12 |
Using Mapped face meshing excludes the use of inflation method. Suppress Mapped face meshing method and you will be able to use inflation.
As siw wrote author uses biasing to create something like inflation. In this case inflation method would do basically the same as biasing. If you want to change some "inflation settings" try to play with size and biasing ( <- more important). |
|
November 17, 2013, 20:40 |
|
#5 |
Member
Nikola
Join Date: Sep 2013
Location: Madrid, Spain
Posts: 60
Rep Power: 12 |
Thank you!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
Fluent diverges when using inflation layers | ziggo | FLUENT | 4 | August 9, 2013 12:11 |
Inflation with Patch conformaing or patch independent | sanlee39 | ANSYS Meshing & Geometry | 0 | June 4, 2013 10:56 |
Needed Benchmark Problems for FSI | Mechstud | Main CFD Forum | 4 | July 26, 2011 12:13 |
ICEM Inflation Problems | deamitdehoa | ANSYS Meshing & Geometry | 3 | October 20, 2009 09:33 |