Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ICEM] Replacing geometry in ICEM without losing Boundary Conditions

Mark Forums Read

Reply

Search this Thread

January 18, 2014, 13:16	Replacing geometry in ICEM without losing Boundary Conditions	#1
RealENG22 Member Steve Mcharg Join Date: Mar 2013 Posts: 31 Rep Power: 13	I have found an error in my geometry - I had previously created BC's, Mesh etc in ICEM. Geometry was imported from CAD software. I have correct and exported the correct geometry in the CAD software. Is there anyway of importing the new geometry without the need to recreate all of the boundary conditions? Cheers!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ribbed channel / simpleFoam / boundary conditions	beeo	OpenFOAM Pre-Processing	20	July 17, 2013 08:39
Boundary conditions Poiseuille flow, Y pipe, 3D geometry	Guenda	OpenFOAM Pre-Processing	0	April 4, 2013 17:33
[ICEM] Problems with geometry when defining boundary conditions	darazsbence	ANSYS Meshing & Geometry	2	February 24, 2013 09:07
boundary conditions problem with mesh created in Icem	darazsbence	CFX	3	February 24, 2013 04:02
ICEM --> FLUENT, boundary conditions	Tobias	CFX	1	July 9, 2007 10:35

All times are GMT -4. The time now is 20:18.