|
[Sponsors] |
January 31, 2014, 22:46 |
Geometry to ansys mesh
|
#1 |
Member
shikha
Join Date: Aug 2013
Posts: 40
Rep Power: 12 |
Dear friends,
I have drawn a 3D assembly figure in creo 2.0 and have imported it to ansys14 for its meshing and fluent analysis.I opened the geometry in design modeller to create it fluid domain but whenever I do the boolean operation of the geometry with the fluid domain,the geometry window(workbench window) automatically converts the tick mark to a question mark and hence cannot be imported to ansys mesh. Please,I will appreciate your any help in this regard. Thank you Shikha |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Scale geometry but mesh size to remain same | sangrampp | ANSYS Meshing & Geometry | 1 | February 12, 2016 05:19 |
[ANSYS Meshing] Meshing Strategy for inside geometry | powpow | ANSYS Meshing & Geometry | 6 | January 16, 2013 04:32 |
Inner geometry gets lost exporting mesh from ICEM CFD to CFX-Pre | powpow | CFX | 3 | December 20, 2012 09:14 |
Ansys mesh for FLUENT software giving unrealistic results, while GAMBIT mesh is fine | kbhamidipa3 | FLUENT | 0 | November 30, 2012 15:52 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |