 |
 |
 |
|
|
|
[Sponsors] | ||||
February 3, 2014, 09:28
|
Curve linking problem
|
#1 |
|
New Member
Tom
Join Date: Feb 2014
Posts: 4
Rep Power: 12  |
Hello,
I am new to ICEM and got confused by a problem: I have unlinked two adjacent curves (one curve's end point to the next curve's starting point， they are collinear) but when I change the nodes of one curve, the other one will change to the same nodes number which is really annoying. Does anyone meet the same problme and could you please let me know how to solve it? Thanks. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Linking Problem in TECIO | nw_ds | Tecplot | 1 | November 6, 2013 11:41 |
| [ANSYS Meshing] blocking 2D planar, problem associate edge to curve | hadrien51 | ANSYS Meshing & Geometry | 10 | February 21, 2012 12:37 |
| Wall shear stress curve!! | ruzfactor | FLUENT | 0 | December 8, 2010 18:33 |
| Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 05:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Linear Mode
