CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Edge Meshing Parameters (http://www.cfd-online.com/Forums/ansys-meshing/130086-edge-meshing-parameters.html)

Mikri February 19, 2014 10:12

Edge Meshing Parameters
 
Is there an easier way to set the edge meshing parameters in ICEM 14.5, so that the edge mesh becomes coarser towards its end points, than using the Spline Mesh law?


All times are GMT -4. The time now is 20:54.