|
[Sponsors] |
[ICEM] Help with troubleshooting periodic setup |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 13, 2014, 23:46 |
Help with troubleshooting periodic setup
|
#1 |
New Member
Sam
Join Date: Feb 2014
Posts: 2
Rep Power: 0 |
Hi everyone, I want to generate unstructured mesh on one section (1/3) of the diffuser as shown here, and apply periodic setting to represent full diffuser 360 degrees.
This is the periodic indication after I have done meshing. My settings were: Base: 0 0 0 Axis: 0 0 1 Angle 120 However, when I do a mesh check it points out that there's problem in periodicity and also when I output to fluent the mesh check in fluent says I have periodic inconsistency. Can someone help me out with this? Thank you so much! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to setup a periodic numerical model | saleh alsubari | Main CFD Forum | 0 | August 22, 2012 04:45 |
[ICEM] Periodic condition between ICEM and FLUENT | Touré | ANSYS Meshing & Geometry | 0 | August 5, 2012 17:00 |
HELP! Periodic Problem | foxer | FLUENT | 1 | June 27, 2012 08:00 |
[ICEM] how to define periodic in icem ? | mingersai | ANSYS Meshing & Geometry | 1 | February 3, 2012 17:46 |
periodic boundary conditions setup | studentcfd | CFX | 4 | October 25, 2007 01:38 |