|
[Sponsors] |
[ICEM] Using "ic_surface multiple" command in batch mode |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 11, 2014, 04:24 |
Using "ic_surface multiple" command in batch mode
|
#1 |
New Member
Gergely Hajgató
Join Date: Jan 2014
Location: Hungary
Posts: 1
Rep Power: 0 |
Hello everybody,
I'm facing a scripting problem in ICEM CFD, whose solution has to be simple, but I can't figure it out. I'm trying to use the "ic_surface multiple" command in a script file, exactly as below: ic_surface multiple SURFS srf.00 {{arista.14 spine.57 arista.2 spine.38} 0 1 0} The batch file runs without error messages, but the surface doesn't get generated. When I copy the exactly same line to ICEM's message window, it works fine. Could anybody tell me, how I could make it work in the script file too? Thanks for your help in advance! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Save images using Fluent in batch processing mode | dixitked | FLUENT | 8 | August 29, 2019 12:25 |
Running Ansys in BAtch Mode | kuleuvenstudent | ANSYS | 1 | October 18, 2017 12:11 |
to run a replayfile in batch mode from UNIX | froztbear | ANSYS Meshing & Geometry | 4 | May 13, 2014 08:00 |
cfdpost in batch mode | taichijulie | CFX | 1 | October 25, 2010 15:29 |
Prosurf in batch mode | Dhruv | Siemens | 1 | September 19, 2005 18:02 |