|March 12, 2014, 23:06||
ICEM troblue for meshing Wedge geography
Join Date: Aug 2013
Posts: 4Rep Power: 4
I use ICEM to mesh wedge geography, but at the point of wedge, the mesh is not perfect(Picture mesh.jpg). my ideal mesh is on picture good.jpg
how can i finish my mesh? i want help.
Additionally, in my opinion, the troblue may relate to this problem in picture The quantities of the edge.
there are 30 points in the edge 1 and 40 points in the edge 2. There are, however, 91 points in the edge 3 ! 30 plus 40 is not equal 91 apparently !
when i change the other quantities of edge 1 or 2, the sum of the quantities of edge 3 is 20 more than the sum of the quantities of the edge 1 and 2.
Why and how to handle it?
thx in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to use an ICEM wedge geometry?||galap||OpenFOAM||7||January 18, 2015 11:10|
|[ICEM] Different meshes from ICEM and GAMBIT||Mojtaba.a||ANSYS Meshing & Geometry||9||March 30, 2013 03:42|
|Axisymmetric Whirl BCs; Wedge or Cyclic?||c_dowd||OpenFOAM Pre-Processing||4||December 5, 2012 11:38|
|Wall boundary is ignored when using wedge||Wedge||OpenFOAM||1||February 7, 2011 07:20|
|Design Modeler to ICEM.....||Joe||CFX||0||January 24, 2008 04:39|