CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > ANSYS Meshing & Geometry

[ICEM] Help with troubleshooting periodic setup

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   March 14, 2014, 00:46
Default Help with troubleshooting periodic setup
  #1
New Member
 
Sam
Join Date: Feb 2014
Posts: 2
Rep Power: 0
cfdworks is on a distinguished road
Hi everyone, I want to generate unstructured mesh on one section (1/3) of the diffuser as shown here, and apply periodic setting to represent full diffuser 360 degrees.






This is the periodic indication after I have done meshing.




My settings were:
Base: 0 0 0
Axis: 0 0 1
Angle 120

However, when I do a mesh check it points out that there's problem in periodicity and also when I output to fluent the mesh check in fluent says I have periodic inconsistency.

Can someone help me out with this?

Thank you so much!
cfdworks is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
how to setup a periodic numerical model saleh alsubari Main CFD Forum 0 August 22, 2012 04:45
[ICEM] Periodic condition between ICEM and FLUENT Touré ANSYS Meshing & Geometry 0 August 5, 2012 17:00
HELP! Periodic Problem foxer FLUENT 1 June 27, 2012 08:00
[ICEM] how to define periodic in icem ? mingersai ANSYS Meshing & Geometry 1 February 3, 2012 18:46
periodic boundary conditions setup studentcfd CFX 4 October 25, 2007 01:38


All times are GMT -4. The time now is 21:58.