|
[Sponsors] |
March 16, 2014, 21:15 |
hexa mesh for turbines using ICEM
|
#1 |
New Member
chiranjivi
Join Date: Mar 2014
Posts: 5
Rep Power: 12 |
Can I get an idea on the meshing techniques for this runner http://www.ltu.se/cms_fs/1.111520!/file/Runner.zip
|
|
March 17, 2014, 00:33 |
|
#2 |
New Member
|
In that geometry Mesh already prepared and included.
(1) Open Geometry in ICEM *.tin file (2) Import block file *.blk (3) Create pre-mesh. (4) Convert to unstructured For You must have knowledge about ICEM CFD Blocking technique. |
|
March 17, 2014, 00:46 |
|
#3 |
New Member
chiranjivi
Join Date: Mar 2014
Posts: 5
Rep Power: 12 |
I wanted to know on how they have done it, especially the blocking of the turbine.
Any ideas on how to recreate the same mesh with the geometry file. |
|
March 17, 2014, 10:38 |
|
#4 |
New Member
|
Then You have to learn blocking techniques. You may start from the tutorial available in ICEM CFD. The blocking can be performed any type of geometry just you have to explore the decomposition technique using available commands.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
ICEM hexa mesh built with v10 deformed in v11 (degenerated edges) | cfxicem | ANSYS Meshing & Geometry | 1 | October 14, 2009 15:06 |
ICEM HEXA to CFX-PRE mesh export pb | jaber | ANSYS Meshing & Geometry | 0 | April 2, 2009 17:21 |
icem hexa mesh beginner | icem beginner | Main CFD Forum | 3 | July 9, 2008 07:08 |
ICEM hexa mesh tutarial 2d car problem | cfduser | FLUENT | 0 | March 8, 2008 16:16 |