|
[Sponsors] |
March 23, 2014, 10:24 |
Problem with volume meshin
|
#1 |
Senior Member
|
Dear all,
I am stil have the same problem, as you will see in the pciture attached, there are some holes in the surface of the volume mesh. This holes appreas on the edge of the domain, I am using Octree and curvature proximity refinement. Do you have an idea of how overcome this issue? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
Problem with negative volume in CFX | TallesC | CFX | 1 | February 4, 2013 16:26 |
[Other] Problem with negative volume in CFX | TallesC | ANSYS Meshing & Geometry | 3 | February 4, 2013 11:44 |
[GAMBIT] Gambit - Problem having shadow wall on volume | ejvikings | ANSYS Meshing & Geometry | 3 | March 23, 2012 01:30 |
Zero Volume Fraction in Free Surface Problem | marega | CFX | 1 | September 10, 2009 06:31 |