CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ANSYS Meshing] Cutcell + inflation - problem with inlet face

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   March 20, 2014, 07:01
Default Cutcell + inflation - problem with inlet face
  #1
New Member
 
Tom
Join Date: Mar 2014
Posts: 19
Rep Power: 12
blowback is on a distinguished road
Hello
How can I make inflation on the all faces without the inlet&outlet using cutcell meshing method? On the picture below you can see inflation, on the inlet, which is not neccessary.
http://s10.postimg.org/t904829bd/inflation.jpg
blowback is offline   Reply With Quote

Old   March 21, 2014, 03:17
Default
  #2
New Member
 
Tom
Join Date: Mar 2014
Posts: 19
Rep Power: 12
blowback is on a distinguished road
I'm using version 14.0 of ANSYS Meshing. I have to use cutcell, because this method of meshing gives the best hexa dominant mesh. Whole geometry is shown below. The problem is with inflation. It doesn't matter what option of inflation I set up, boundary layer is very thin. I think the problem is inflation layer created on front and back face - do u know how can I remove it?

http://s3.postimg.org/yxb01yuo1/problem.jpg

On the picture is shown only mesh which was done at small piece of whole geometry
blowback is offline   Reply With Quote

Old   March 26, 2014, 03:18
Default
  #3
New Member
 
Tom
Join Date: Mar 2014
Posts: 19
Rep Power: 12
blowback is on a distinguished road
I solved my problem. Named selections for inlet and outlet face were needed.
blowback is offline   Reply With Quote

Reply

Tags
cutcell, inflation layer

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
area does not match neighbour by ... % -- possible face ordering problem St.Pacholak OpenFOAM 10 February 7, 2024 22:50
[GAMBIT] Problem in link face mesh for periodic newbie384 ANSYS Meshing & Geometry 1 June 28, 2013 07:31
[ANSYS Meshing] Inflation on common Face using cutcell mesh foamcfd ANSYS Meshing & Geometry 0 July 31, 2012 09:20
channelFoam for a 3D pipe AlmostSurelyRob OpenFOAM 3 June 24, 2011 14:06
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues michele OpenFOAM Meshing & Mesh Conversion 2 July 15, 2005 05:15


All times are GMT -4. The time now is 03:52.