 |
 |
 |
|
|
|
[Sponsors] | ||||
April 3, 2014, 01:30
|
Out of memory when meshing geometry
|
#1 |
|
New Member
Dziyad Dzulfansyah
Join Date: Jan 2014
Location: Bogor
Posts: 11
Rep Power: 12  |
hello everybody,
i mesh the 3D geometry with "interval count" 30, but when meshing is running, "out of memory" happens and meshing is stopped. Anybody know why it happen? What i have to do? Thanks a lot |
|
|
|
|
|
April 3, 2014, 01:43
|
|
#2 | |
|
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
Quote:
In Gambit this is a typical issue if you want to mesh a geometry on the fly without decomposition. So you have to divide your geometry into several subvolumes, and tehn mesh each subvolume separately
__________________
In memory of my friend Hervé: CFD engineer & freerider  |
||
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lenovo C30 memory configuration and discussions with Lenovo | matthewe | Hardware | 3 | October 17, 2013 10:23 |
| [ANSYS Meshing] Using more than one meshing method on a single 2D geometry | robbierich90 | ANSYS Meshing & Geometry | 0 | October 30, 2011 13:12 |
| Need help on meshing this simple geometry | nha1g08 | ANSYS Meshing & Geometry | 3 | March 9, 2011 02:13 |
| 3d Gambit meshing shows out of memory | tamjid | FLUENT | 3 | September 27, 2008 01:01 |
| our of memory in meshing | BAOYU | FLUENT | 0 | February 8, 2006 12:16 |
Linear Mode
