[vivekananda]

Hi,

I am having a problem with drawing geometry. I have made a two body system, one body is inside the other. The interface that is being created is having following regions

contatc_region_src
contact region_trg
wall 11
wall 12
wall 8
wall 8 shadow

Is this a correct interface?
Why there is so much walls?
Is there any tutorials available for interface creation in 3D geometry using ansys 14.5?

Please someone answer.

[tmeysam92]

Originally Posted by vivekananda

Hi,

I am having a problem with drawing geometry. I have made a two body system, one body is inside the other. The interface that is being created is having following regions

contatc_region_src
contact region_trg
wall 11
wall 12
wall 8
wall 8 shadow

Is this a correct interface?
Why there is so much walls?
Is there any tutorials available for interface creation in 3D geometry using ansys 14.5?

Please someone answer.

do you use fluent? if yes, so i think it is correct. your mesh in interface is not conformal, so when you import mesh to fluent it automatically creates interface mesh.

[thummala]

Originally Posted by tmeysam92

do you use fluent? if yes, so i think it is correct. your mesh in interface is not conformal, so when you import mesh to fluent it automatically creates interface mesh.

i created mesh for 2d airfoil with c type domain in ansys design modeler but iam not getting very fine mesh near to the airfoil wall, how can i get fine mesh please help me i'm doing project on this,and i follwed below links to do the mesh
https://www.youtube.com/watch?v=LAIB7qK-9pE
https://www.youtube.com/watch?v=FQK51-cb-78