|June 24, 2014, 14:34||
Uncovered Edges in Fluent CFD
Join Date: Jun 2014
Posts: 5Rep Power: 3
I have a big Problem. I construct a filling system for oil tanks in 2D. Even when I try to export the Mesh, I get the Warning "Mesh has uncovered Edges". Until now I canīt solve it, by merging vertics and blocks :-(. Maybe you have just a little time to have a lock on it :-).
It would be great, if you have any idea, about the solution
Regards, Tommy :-)
|June 25, 2014, 09:39||
Join Date: Feb 2013
Posts: 171Rep Power: 13
Attachment 1 and 2 show the results of Check Mesh in ICEM. There are problems with overlapping an degenerated blocks (att3). Also your mesh is not conformal in this area.
As I do not know what you did exactly, I just recreated this part of the blocking. First I deleted all problematic blocks permanently, except for block 160. Then I created some new points by projection on curve (att4, lower points of block 160) and added a split to block 160. The vertices of this block have to be associated to the corresponding points. Block 344 can also be deleted permanently. This gives you the structure shown in attachment 5.
Now, new blocks have to be created. Mind the order of picking the vertices (att6). The very left block can be created by associating (to points) the corresponding vertices from VORFN and assigning block 521 to part FLUID. Finally the new edges are associated to curves. Attachment 8 shows the resulting blocking. Btw. single-edges are ok on the boundaries.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Now Possible to have Open-Source Real Gas Properties in FLUENT (and other CFD codes)!||ibell||Main CFD Forum||2||March 4, 2014 03:39|
|Export mesh from ICEM CFD for Fluent||summerdream||ANSYS||2||September 10, 2013 12:12|
|snappyHexMesh won't work - zeros everywhere!||sc298||OpenFOAM Native Meshers: snappyHexMesh and Others||2||March 27, 2011 21:11|
|Chemkin CFD for Fluent||divyatman||FLUENT||1||July 20, 2009 13:44|
|CFD Design...The CFD Future||John C. Chien||Main CFD Forum||19||October 6, 1999 11:57|