Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ANSYS Meshing] ignoring a part while meshing

Mark Forums Read

Reply

Search this Thread

August 1, 2014, 05:02	ignoring a part while meshing	#1
Arjun kumar P New Member P Arjun kumar Join Date: Jun 2014 Posts: 4 Rep Power: 11	hi friends, i am new to ICEM CFD actually i am facing a problem that Propeller is not meshing it pops in console window as "Part IMPELLER contains geometry and body in same part. This is not recommended and could cause problems! Part IMPELLER will be ignored."can any one please help me" Thanks in Advance..!! Arjun

Reply

Tags

ignoring a part in mesh

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Meshing container	Dream12	ANSYS Meshing & Geometry	2	October 17, 2013 17:31
[ICEM] Meshing one body part only	serezhkin	ANSYS Meshing & Geometry	3	June 29, 2010 15:36
Meshing of very complicated part	Sanjay Jain	FLUENT	9	April 7, 2009 00:21
meshing hollow part of pipe	rai	FLUENT	0	December 19, 2005 00:46

All times are GMT -4. The time now is 18:13.