|
[Sponsors] |
August 14, 2014, 02:30 |
Non-positive volume exist
|
#1 |
Senior Member
Amin
Join Date: Oct 2013
Location: Germany
Posts: 397
Rep Power: 14 |
Hi everyone!
I'm facing a famous error! "Non-positive volume exist" I'm using ansys meshing for grid generation and then importing this mesh to fluent! But when I check the mesh, fluent says this error! I found some solution for GAMBIT and ICEM but for ANSYS MESHING there isn't any help! Do you have any suggestion for my problem!?? Best regards |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
Courant number blowing up, non-orthogonal mesh? | odellar | OpenFOAM Running, Solving & CFD | 5 | October 22, 2013 19:50 |
[ICEM] non positive volume | nabaen | ANSYS Meshing & Geometry | 8 | August 16, 2013 13:10 |
Non positive volume after solver settings | callofduty | FLUENT | 0 | April 8, 2009 04:50 |
[Commercial meshers] CuBit | t42 | OpenFOAM Meshing & Mesh Conversion | 6 | July 10, 2008 07:51 |