|September 9, 2014, 09:26||
ICEM - Volume Mesh
Join Date: Oct 2012
Posts: 51Rep Power: 5
i have a wing + aileron + flap geometry for which i am creating a mesh to be used
for external flow analysis of course.
i am creating a box domain around and then using 'build topology' with tolerance of 1 mm which is giving all RED curves ..thereafter creating 'BODY' using 'topology/all surface selection'
afterwards i go to the Global & Part Mesh Setup to give the sizing
(this being a first cut mesh so i am not aiming for a very fine mesh at this stage)
here's the PROBLEM :
when i generate the volume mesh for this domain the tetra mesh does not take care of the cavities in the domain which should be because of the geometry within the box domain ..why this , how to correct it ?
|Thread||Thread Starter||Forum||Replies||Last Post|
|SnappyHexMesh for internal Flow||vishwa||OpenFOAM Native Meshers: snappyHexMesh and Others||23||August 6, 2014 03:50|
|Problem of simulating of small droplet with radius of 2mm||liguifan||OpenFOAM Running, Solving & CFD||5||June 3, 2014 02:53|
|non-orthogonal faces and incorrect orientation?||nennbs||OpenFOAM Native Meshers: blockMesh||7||April 17, 2013 05:42|
|BlockMesh FOAM warning||gaottino||OpenFOAM Native Meshers: blockMesh||7||July 19, 2010 14:11|
|Convergence moving mesh||lr103476||OpenFOAM Running, Solving & CFD||30||November 19, 2007 15:09|