|
[Sponsors] |
September 9, 2014, 10:26 |
ICEM - Volume Mesh
|
#1 |
Member
Sandeep
Join Date: Oct 2012
Location: India
Posts: 51
Rep Power: 13 |
hi,
i have a wing + aileron + flap geometry for which i am creating a mesh to be used for external flow analysis of course. i am creating a box domain around and then using 'build topology' with tolerance of 1 mm which is giving all RED curves ..thereafter creating 'BODY' using 'topology/all surface selection' afterwards i go to the Global & Part Mesh Setup to give the sizing (this being a first cut mesh so i am not aiming for a very fine mesh at this stage) here's the PROBLEM : when i generate the volume mesh for this domain the tetra mesh does not take care of the cavities in the domain which should be because of the geometry within the box domain ..why this , how to correct it ? thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
Problem of simulating of small droplet with radius of 2mm | liguifan | OpenFOAM Running, Solving & CFD | 5 | June 3, 2014 03:53 |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 06:42 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 15:09 |