|September 12, 2014, 06:26||
Tips on how to improve the quality of this mesh
Join Date: Mar 2014
Posts: 3Rep Power: 3
Is it possible for anyone to have a look at my attached mesh and advise me on how the quality or overall strategy of the blocking could be improved?
At the moment the minimum quality is only 2.5
Also, is the meshing for the boundary layer adequate?
I'm using the SST turbulence model in fluent to run a simulation and with this mesh can't reach convergence, however, with a less dense mesh, i am able to reach convergence.
|blocking strategy, icem, improve, mesh, quality|
|Thread||Thread Starter||Forum||Replies||Last Post|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||6||August 26, 2015 09:38|
|[ICEM] Negative volume error in hybrid mesh||siw||ANSYS Meshing & Geometry||4||September 3, 2014 05:25|
|[ICEM] improving mesh quality||kannstmasehn||ANSYS Meshing & Geometry||8||April 29, 2013 05:28|
|[ICEM] Tetra mesh quality before and after prism layer||Chander||ANSYS Meshing & Geometry||0||December 25, 2011 23:04|
|fluent add additional zones for the mesh file||SSL||FLUENT||2||January 26, 2008 12:55|