|
[Sponsors] |
[ICEM] after generating y-block there strange associations |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 27, 2014, 13:08 |
after generating y-block there strange associations
|
#1 |
Member
Robert Bischof
Join Date: Aug 2014
Posts: 56
Rep Power: 11 |
Hello together,
I'm just meshing a bent part. There iss a sharp edge at the end, where I need a Y-Block. Before I generate the y-block, the mesh is ok, but after that, there are strange associations and the mesh is ruined. The atachment shows the mesh without y-block and the ruined mesh. Is there a Bug ? Or do someone know, how I can rescue my mesh ? Without the y-block the mesh quality is to poor for simulation. I think it's a problem with associations, but I tried all things I know for this problem (New associations of the edges to curves, vertex to curve, vertex to surface) but nothing fix the problem. |
|
September 29, 2014, 04:27 |
|
#2 |
Member
Robert Bischof
Join Date: Aug 2014
Posts: 56
Rep Power: 11 |
Important:
The problem seems like a bug of ICEM 15.0. The same operation with ICEM 14.5 works without any problem. |
|
October 1, 2014, 05:33 |
|
#3 |
Senior Member
Gwenael H.
Join Date: Mar 2011
Location: Switzerland
Posts: 392
Rep Power: 20 |
You should try to update the edge pre-mesh parameters, sometimes when you create your Y-block the parameters are not properly copied to the new edges.
PS: Also encountered when I started to work on the V15 |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Mixer mesh - negative volume problem | jadtwo | OpenFOAM Meshing & Mesh Conversion | 2 | November 6, 2014 16:37 |
foamLog not solving for Ux, Uy, Uz | aerospain | OpenFOAM Post-Processing | 5 | April 18, 2012 10:01 |
Doxygen documentation | Tanay | OpenFOAM Installation | 9 | September 23, 2011 11:40 |
ParaView and Qt 4.3.5 on Mac OS X 10.6 | Adrian | OpenFOAM | 3 | August 8, 2010 03:16 |
[Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 02:58 |