|
[Sponsors] |
February 1, 2012, 05:28 |
fill tool
|
#1 |
New Member
Alessandra
Join Date: Jan 2012
Posts: 14
Rep Power: 14 |
Hey.. I have a problem with the tool "fill" of DM. At first I had a pipe with 8 hole at the end (see the figure) and I have done the "fill with cap". Now I done this pipe as 3 different body because I should to mesh in different way. Now I'm working with 1/4 of geometry. The bodies are frozen and one is an active body because I'm not able to make the holes in a frozen body. When I tried to "fill" the single and 4/4 pipe everythink was ok, with a single and 1/4 pipe ansys told me that "No new fill volume was created from selected body sets" and that "cannot create inverse volume". This error is shown also whit the 3 different body and 1/4 geometry... It's seems that the problem is working with 1/4 geometry... What's the problem??
Thank you Last edited by alecon88; February 1, 2012 at 12:19. |
|
February 1, 2012, 12:25 |
|
#2 |
New Member
Alessandra
Join Date: Jan 2012
Posts: 14
Rep Power: 14 |
I have found a solution!!!! I would like to delete this post but I'm not be able :-)
|
|
March 24, 2012, 16:25 |
solution
|
#3 |
New Member
alex red
Join Date: Mar 2012
Posts: 1
Rep Power: 0 |
what was your solution to that problem?? i have the same error that pops up when i try to create a volume using the fill tool.
any help would be appreciated..thanks |
|
October 16, 2014, 04:27 |
|
#4 |
New Member
Florin Gheorghe
Join Date: May 2013
Location: England
Posts: 24
Rep Power: 12 |
Hello Alessandra,
Can you share the solution for this? I have the same problem and I cannot find a work around. If anybody has an idea, please help.
__________________
Best regards, Florin |
|
October 16, 2014, 05:18 |
|
#5 |
New Member
Alessandra
Join Date: Jan 2012
Posts: 14
Rep Power: 14 |
Unfortunately I don't remember which was the solution, it was long time ago and I had several problems. Maybe I solved it adding a new surface or creating a quarter geometry since the beginning.
|
|
October 16, 2014, 07:54 |
|
#6 |
New Member
Florin Gheorghe
Join Date: May 2013
Location: England
Posts: 24
Rep Power: 12 |
It's OK, I figured it out.
The problem was that I had a small surface that made the body to be open, that is it was not water tight.
__________________
Best regards, Florin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Y+ Estimation Tool | pete | Site News & Announcements | 1 | August 4, 2011 04:49 |
Tool for converting and estimating turbulence boundary conditions | pete | Main CFD Forum | 1 | June 20, 2011 13:52 |
Modeling of a Forging Tool. | hydro | CFX | 1 | May 19, 2010 18:35 |
[mesh manipulation] ScalePoints tool | cedric_duprat | OpenFOAM Meshing & Mesh Conversion | 6 | September 19, 2008 03:15 |
Parametrical tool? | Renaud | FLUENT | 0 | May 25, 2006 04:51 |