|October 17, 2014, 09:35||
Use Several Hexa Domains in Ansys Fluent
Join Date: Nov 2010
Posts: 49Rep Power: 6
In Design Modeler I modeled several concentric pipes (all of them modeled as frozen volumes, connnecting surfaces identified by the named selection tool, etc), which I later meshed in ICEM using Hexa meshing (blocking) strategy.
When I open the mesh in Fluent I only see one single domain, not the four (04) domains I need for my simulation.,
So the question is how to set things in ICEM to later see the separated domains in Fluent...
Thanks in advance...
|domain, hexa, icem|
|Thread||Thread Starter||Forum||Replies||Last Post|
|prePDF preprocessor in FLUENT (ANSYS 12 version)||anee||Fluent UDF and Scheme Programming||7||March 18, 2013 23:57|
|few quesions on ANSYS ICEMCFD and FLUENT||Prakash.Paudel||ANSYS||0||August 12, 2010 12:07|
|export data from fluent to ansys||galapago||FLUENT||0||August 4, 2010 14:04|
|Fluent & Ansys FSI architecture help||DillonS||FLUENT||1||April 7, 2010 16:00|
|Hot News: Ansys Buys Fluent||Jonas Larsson||Main CFD Forum||23||February 22, 2006 18:12|