|
[Sponsors] |
October 24, 2014, 14:30 |
Mesh quality
|
#1 |
New Member
siddharth hans
Join Date: Sep 2014
Posts: 4
Rep Power: 11 |
Hi guys, are mesh aspect ratio, orthogonal quality and skewness the only factors at the end of the day which decide whether a mesh is good or not? If no what are the other factors?
Pardon me if this is a stupid question. Just a beginner |
|
October 27, 2014, 10:09 |
|
#2 | |
Senior Member
Amin
Join Date: Oct 2013
Location: Germany
Posts: 397
Rep Power: 14 |
Quote:
All of them are important! If you read ANSYS meshing manual you will find some helpful guidance! |
||
October 27, 2014, 10:12 |
|
#3 |
New Member
siddharth hans
Join Date: Sep 2014
Posts: 4
Rep Power: 11 |
Thanks alot amin! Will do that.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Polyhedral Mesh Quality in Star-CCM+ | niazaliahmed | STAR-CCM+ | 3 | March 8, 2012 13:51 |
[ICEM] Tetra mesh quality before and after prism layer | Chander | ANSYS Meshing & Geometry | 0 | December 25, 2011 22:04 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |