 |
 |
 |
|
|
|
[Sponsors] | ||||
November 3, 2014, 20:00
|
sweep meshing
|
#1 |
|
Senior Member
Join Date: Mar 2014
Posts: 375
Rep Power: 13  |
My assembly has got a number of different parts imported from solidworks, ansys meshing shows them as sweepable if they are not formed into a single part in design modeller, but if i form them as one part, then they are not shown as sweepable, i have tried slicing the body as well in design modeller but it still doesnt help, any ideas? i am thinking it might actually be a bug?
|
|
|
|
|
|
November 4, 2014, 08:05
|
|
#2 |
|
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 22 |
Its not a bug for sure. Have you tried manually selecting source and target faces for sweeping?
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] inflation on the face other than source face of sweep meshing? | jayash | ANSYS Meshing & Geometry | 0 | April 16, 2014 04:11 |
| inflation problem in sweep meshing | jayash | Main CFD Forum | 0 | April 15, 2014 04:38 |
| inflation with sweep meshing | jayash | FLUENT | 0 | April 11, 2014 08:46 |
| [ANSYS Meshing] Unwanted bias while meshing a tube with sweep and inflation | rasko | ANSYS Meshing & Geometry | 7 | July 23, 2012 10:31 |
| [ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Linear Mode
