|November 16, 2014, 09:43||
Sharing Faces, no connection
Join Date: Nov 2014
Posts: 1Rep Power: 0
I'm struggling with problem about connection of the mesh in Ansys.
I have the face as in the picture that i split with plane. Just to get as much conformal mesh as it can be achieved. I mean using the size edge. But the problem is that there is no connection between this faces. Im not familiar with the root of that problem.
1. I designmoduler all that faces are in the one part.
2. And the mesh still brake in connections between those faces.
Someone have idea what to do ?
Of course shared topology is set to :
|Thread||Thread Starter||Forum||Replies||Last Post|
|Foam::error::PrintStack||almir||OpenFOAM Running, Solving & CFD||51||June 28, 2015 16:36|
|snappyhexmesh remove blockmesh geometry||philipp1||OpenFOAM Running, Solving & CFD||2||December 12, 2014 11:58|
|Decomposing meshes||Tobi||OpenFOAM Pre-Processing||1||September 9, 2014 05:30|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||2||November 25, 2012 09:54|
|[Other] Mesh Importing Problem||cuteapathy||ANSYS Meshing & Geometry||1||June 7, 2012 13:39|