|
[Sponsors] |
November 27, 2014, 02:03 |
Blocking stratery
|
#1 |
New Member
|
Hello!
I built a simple geometry for training blocking method in ICEM. When I split one initial block for creating block structure, there is no questions. But when I create blocks separetly, one after another, with the merge option, the mesh from middle block sandwiches on the mesh from neighboring blocks. I understand that in case of a simple geometry it is better to split one initial block. But in case of a big assembley it is better to create blocks separetly. How can I avoid mesh sandwich in case of creating blocks separetly? May be delete face...? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Blocking | wali | ANSYS Meshing & Geometry | 2 | September 8, 2014 14:19 |
[ICEM] Problem to load the blocking | biasilveira | ANSYS Meshing & Geometry | 2 | February 24, 2013 22:04 |
[ICEM] Blocking and Symmetry | BrolY | ANSYS Meshing & Geometry | 32 | August 24, 2012 03:13 |
[ICEM] Using Blocking with ICEM (infinite blocking lines appeared) | Touré | ANSYS Meshing & Geometry | 2 | August 5, 2012 17:27 |
[ICEM] Blocking strategy | BrolY | ANSYS Meshing & Geometry | 0 | July 22, 2010 04:46 |