 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] O-grid intersection between two perpendicular cylinders |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 25, 2014, 02:41
|
O-grid intersection between two perpendicular cylinders
|
#1 |
|
New Member
Abhijit
Join Date: Dec 2014
Location: IIT kanpur
Posts: 3
Rep Power: 11  |
It is a cuboid having 2 cylinders on adjacent faces extruded some height from the surface of cuboid. I am trying to generate O-Grid on the surface of both cylinder. Technically these O-grid will be intersecting somewhre in the middle of cuboid. Will it have some impact on meshing quality..? is there any alternate way to avoid this problem and be able to create o grid on the face of cylinders.
i have attached the image Last edited by abhiaero; December 25, 2014 at 08:41. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] How to mesh 2 cylinders that are perpendicular? | despaired student | ANSYS Meshing & Geometry | 6 | June 7, 2012 10:07 |
| [ICEM] How to connect 2 cylinders that are perpendicular to eachother | despaired student | ANSYS Meshing & Geometry | 1 | April 18, 2012 09:30 |
| Grid Adaptation | Suresh | FLUENT | 0 | October 15, 2003 13:18 |
| GRID TO GRID INTERPOLATION in FLUENT | calogero | FLUENT | 3 | June 4, 2003 08:32 |
| Numerical methods for discontinuous grid interfaces? | Hansong Hang | Main CFD Forum | 12 | September 16, 1998 22:26 |
Linear Mode
